Fay Butler Fab/Metal Shaping

Offset Snips for Sale

Offset Snips

For cutting above sheet surface, such as holes.

  • Meet ASME standards
  • Cutting capacity 18 ga. CR - 22 ga. SS.
  • Made in the USA
  • Available in 2 styles
    Red grips, cuts left
    Green grips, cuts right
  • 10.5" with 1.375" cut

$45. each plus $12.00 s/h (U.S. orders only)

These snips are a must for cutting a hole in a sheet where your hand needs to be offset above the sheet.   — F.B.

The jaw area of the snip is stamped out of a flat plate of rolled alloy steel, then hardened, resulting in a fine grain having more toughness for resisting chipping and holding a sharp edge. Unlike all other brands that are investment castings with course grain that chip and have little ware resistance. Another feature is hardened pivot bolts. Self-locking nuts are used to allow for easy adjusting of shear blade gap. Klenk™ was the original manufacturer of aviation snips starting in 1934. This brand of snips will outlast and outperform all others on the market.

Colors

 

©2005-2023 Fay Butler